Fishing friends share the separation of live insects and dead insects in red worms

In daily fishing, whether it is wild fishing or black hole fishing, red fishing bait is an indispensable bait, especially in the cold winter, with its far-fetched bass and bass fishing effect is far Higher than other bait. However, no matter what method you use, it will inevitably appear dead during the preservation of the insect bait. Is there any saving technique? How to separate dead insects from live insects when there are more dead insects? Below, the author will come to share some small methods with you, I hope you like it.

More convenient way to save is to put 50 grams of red worm bait in a glass or stainless steel container, add the appropriate amount of water, so that the water flooded the body about 15 mm, and then put in the refrigerator freezer can. Every two or three days, the dead insects are picked out with tweezers, and then rinsed several times with water of the same temperature and replaced with new ones. However, this method is only applicable when the amount of insect fishing baitis relatively small. If the amount is large, the effect of this method is not very good. How do you pick out dead insects when there are more bugs?

Some professionals often use rinsing methods for red worms, using the principle of different quality of living insects and dead insects, using professional tools to separate dead insects from live insects. But what do you do when you encounter this situation for most of your friends who do not have professional tools?

First of all, we must make it clear that the live red worms will move, but the dead worms will not move. In fact, this can easily separate the two.

Slope separation

Look for a piece of wood, 30-40 cm in width, length, and then find a few newspapers to prepare materials. The specific method of operation is: first spread the newspaper on the table, and then put on the board, when putting the board to pad something at one end, so that the board is about 20 degrees slope. 

The newspaper is also spread on the wooden board, and then the washed worm bait can be placed on the upper side of the slope. When you put them, do not rely on the edges so that they can crawl behind. Live red worms move slowly at this time, and gradually climb to the lower end with the inflow of moisture, while the dead insects in the red worm fishing bait are left in place. However, this method is often not so clean, and it often requires the angler to pick it up again.

2. Live worm drilling

Look for a container with holes above it, such as baskets, bamboo sieves, etc. The size of the hole is preferably about 4mm. Then find a washbasin. The volume is bigger than the former. Pour half a basin of water into the washbasin, then place two broken chopsticks inside the bowl, place the red insects in the water, and then place the container filled with small eyes. Because of the support of the chopsticks, the insects can swim freely in the water and seek to hide under the drive of their instincts to drill into the eyes of the hole to achieve the purpose of separating the dead insects from the live insects.